Hungarian RC trial Championship 2013


Description of the vehicles:

- Plastic, wooden or metal body only
- Full body needed, including doors, read and front bumpers, drop or faltbeds etc..
- Front windschield is required
- Closed body with doors (e.g. stock Pajero body). For roofless/open/cabrio vehicles full interior and roll cage are required (dash, seats, trasmission, side panels)
- All tires must be the same
- Only front wheel steering allowed
- Batteries must be attached to the chassis (axle or link mounts are not allowed)
- At least half of the wheel must be under the body (including fenders)
- DIG or any similar axle braking system is not allowed
- Ladder frame (e.g. Axial SCX) and Tamiya XC/CC/TA like chassis BOTH allowed, but
- Crawler and stick chassis are not allowed!
- One car per competitor allowed
- Minimal light system required (2 white LEDs at front and 2 red LEDs at rear)
- Minimal wheelbase: 242mm
- Minimal track width: 190mm (measured from the outer side of the tyres)

Suspension:
- 4 shocks required with vertical mount (+-20 deg. difference allowed only - no crawler style mounts!)

Tires, wheels:
- All 1.55 and 1.9 tires and wheels allowed, but
- Maximal tyre diameter is 116mm.


Drive:
- Single, electric motor allowed only (can be brushed or brushless)
- No battery size, voltage or capacity limitation (e.g. LiPo)

Winch and external tools
- Wich usage is for +5pt/connection, except free winch points
- External helping tools, carried by the vehicle, presented upon entry, is allowed (e.g. rope, ramps)



The race:
- Time has less importance than scale look and precisitiy.
- Starting points are 200.
- The scale point are deducts these at entry (max. 40pt).
- After the completed race, the collected faults are added.
- The less point are the better.
- Average gate width: 26cm
- Any tuch of a gate +15pt
- Hand tuch of the vehicle (e.g. manual roll over): +30pt
- All gates must be completed, at least tried to complete. Gate miss: +30pt
- Repair time during the event is maximum 1x5 minutes. (If the repair is not done under this time, the competitor will be disqualified)
- Starting order is drawn after the last entry.
- One driver can enter only one Class!
Missing mandatory scale accessiores: +10pt/item

Practice:
- Off-track local pactice is allowed, not disturbing the actual competitor.




Scale poins: ................................................stock.................home made

- Showel, jack, ropes, boxes etc. ……................ 1pt....................2pt
- Working doors ............................................ 3pt....................6pt
- Full interior.................................................. 2pt...................4pt
- Full engige room .......................................... 2pt....................4pt
- Leaf spring suspension.................................. 4pt.....................6pt
- Fake spare wheel..........................................1 pt...................2pt
- Real spare wheel.......................................................3pt
- Metal roof rack............................................ 2pt.....................4pt
- Plastic roof rack........................................................1pt
- Working winch .............................................3pt.....................6pt
- Fake winch...............................................................1pt
- Simple lights ................................................1pt.....................2pt
- Scale lights (turn signal, brake lights, etc)..........2pt....................4pt
- working windschield wiper................................2pt....................4pt
- sleeping bag, polifoam, hand tools.................................1pt
- scale driver...............................................................2pt
- Roll cage - external....................................................2pt
- Roll cage - internal.......................................metal 2 pt, plastic 1pt
- Sand ladder.................................................metal 2 pt, plastic 1pt
- Hidden body mounts ...................................................2pt
- Racecar reproduction (100%).......................................5 pt
- Scale tyre (smaller tyre, like on real cars, e.g.
mud trasher under Yota, tyre is under the body).............. 3pt




CLASS 1 rules
1. Full hard body (e.g. stock or modified Tamiya Pajero, Hilux etc. or handmade styrene bodies e.g. Leo's G Mercedes )
2. Front windshield and door windows
(if you dont have windows, the car must have full interior)
3. bumpers (front + rear)
4. 1 box
5. 1 tow rope
6. 1 jerry can
7. windshield wipers (fake)
8. first aid kit
9. scale license plate with country code (based on your contry regulations)
furthermore, waterproof electronics and winch are advised


CLASS 2 rules
differences from Class1:
1. lexan body (e.g. stock or modified Axial or Proline bodies)




Points are based on rankings on each event:
1st. place......20pt
2nd. place.....18pt
3rd. place......15pt
4th. place......12pt
5th. place......10pt
6th. place........8pt
7th. place........6pt
8th. place........4pt
9th. place........2pt
10th. place......1pt

Your questions and remarks are welcomed here

Thank you guys for the translation - sounds very cool and i think there would be no problem with the rules!

One question: How many sections are to drive on a event? And how long would be the drive time? Ok, that was 2 questions

With best regards,
Gerry

_________________
RC4WD - Teamdriver
Team Stonerockers Austria
RCBM - Scaleparts Teamdriver

Hi Gerry!


Usually there are two stages on an event. The usual drive time is between 10-30 minutes on each stage, depending on the driver.

Thanks for the info!

_________________
RC4WD - Teamdriver
Team Stonerockers Austria
RCBM - Scaleparts Teamdriver

Updates are marked with red:
- Missing mandatory scale accessiores: +10pt/item
- The scale point are deducts these at entry (max. 40pt).